Engineering Symbols
This page lists all the various symbols in the Engineering Symbols category.
Engineering is the discipline, art, and profession, that applies scientific theory to design, develop, and analyze technological solutions. In the contemporary era, is generally considered to consist of the major basic branches of chemical engineering, civil engineering, electrical engineering and mechanical engineering. There are numerous other engineering sub disciplines and interdisciplinary subjects that are derived from concentrations, combinations, or extensions of the major engineering branches.
Symbols in this category:
Ammeter Symbol
An ammeter is a measuring instrument used to measure the electric current in a circuit.
AND gate
An AND gate is a digital logic gate that performs the "AND" function on two inputs, that is, the output is HIGH(1) if both inputs are HIGH(1).
Battery
The symbol for a battery in a circuit diagram. It originated as a schematic drawing of the earliest type of battery, a voltaic pile.
Capacitor
A capacitor (originally known as condenser) is a passive two-terminal electrical component used to store energy in an electric field.
Current source
A current source is an electronic circuit that delivers or absorbs an electric current which is independent of the voltage across it.
Diode
In electronics, a diode is a two-terminal electronic component with an asymmetric transfer characteristic, with low (ideally zero) resistance to current flow in one direction, and high (ideally infinite) resistance in the other. A semiconductor diode, the most common type today, is a crystalline piece of semiconductor material with a p–n junction connected to two electrical terminals. A vacuum tube diode is a vacuum tube with two electrodes, a plate (anode) and heated cathode.
Fuse
In electronics and electrical engineering, a fuse (from the French fuser, Italian fuso, "spindle") is a type of low resistance resistor that acts as a sacrificial device to provide overcurrent protection, of either the load or source circuit. Its essential component is a metal wire or strip that melts when too much current flows, which interrupts the circuit in which it is connected. Short circuit, overloading, mismatched loads or device failure are the prime reasons for excessive current.
NAND gate
A NAND gate is the equivalent of an AND gate with a NOT gate on the output. The output of a NAND gate is HIGH(1) as long as both inputs are not HIGH(1).
NOR gate
A NOR gate is the equivalent of an OR gate with a NOT gate on its output. The output of NOR gate is only HIGH(1) if both of its inputs are LOW(0).
Resistor
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element.
Symbol of Resistivity
The symbol for electrical resistivity is represented by the Greek letter "ρ" (rho). The unit of electrical resistivity in the International System of Units (SI) is ohm-meter (Ω·m). Resistivity is a measure of a material's inherent resistance to the flow of electric current.
The Electronic Switch Symbol
In electrical engineering, a switch is an electrical component that can break an electrical circuit, interrupting the current or diverting it from one conductor to another.
The Inductor Symbol
An inductor, also called a coil or reactor, is a passive two-terminal electrical component which resists changes in electric current passing through it.
Citation
Use the citation below to add this symbols category to your bibliography:
Style:MLAChicagoAPA
"Engineering Symbols." Symbols.com. STANDS4 LLC, 2024. Web. 10 Nov. 2024. <https://www.symbols.com/category/26/Engineering+Symbols>.
Have a discussion about the Engineering Symbols category with the community:
Report Comment
We're doing our best to make sure our content is useful, accurate and safe.
If by any chance you spot an inappropriate comment while navigating through our website please use this form to let us know, and we'll take care of it shortly.
Attachment
You need to be logged in to favorite.
Log In